Minibike Go Kart Clutch 3/4″ Bore 10 Tooth with #40/41/420 Chain

Heavy Duty 10T Sprocket with 40/41/420 Chain 212cc Predator Belt Drive Centrifugal Clutch 3/4″ Bore Designed for 2-7Hp 212 Predator Engines Clutch Performance Parts 3 4 inch Centrifical Clutch for Single Wheel Belt Direct Drive Karts with Tires No Larger Than 15″ Tall Fitment: Fits Yerf-Dog karts with Tecumseh Fits 2 – 6.5HP Small Engines HONDA GC160, GC190, GX120, GX140, GX160, GX200
You Will Get: 1 x 12 teeth centrifugal clutch1x #40/41/420 chain Set Screws NOT Included.
Specifications:

Centrifugal clutch designed to be used on one wheel karts with rear tires no larger than 15″ tall, and engines 2hp-7hp. Larger tires and live axles recommend using Torque-converter ( ASIN:B07T1KRS4V)

Clutch Bore: 3/4″

Sprocket: 10 teeth for #40/41/420 Chian

Clutch Dia: 107mm

Clutch Height: 55mm

Engagement Speed: 2300 300 RPM

Recommended Engine: 2HP – 7HP, 3/4″ shaft with flat key

Fitment: Fit for 2-6.5hp Honda & Honda cloned engines GC160, GC190, GX120, GX140, GX160, GX200 Perfect for Go Kart Minibike Baja Mini Bike MB165 & MB200 (Baja Heat, Mini Baja, Baja Warrior) Common clutch for 3.5-7hp engines using #35 Chain Briggs & Stratton and 2 – 6.5 HP with 3/4″ Shaft Tecumseh Engines 2 – 7 HP with 3/4″ Shaft
How Do You Install A New Clutch on A Go Kart ASSEMBLY INSTRUCTIONS:

Step 1: Remove outer drive cover. Loosen nuts on bottom of engine mounting plate allowing engine to slide back,loosening drive chain.

Step 2: Remove drive chain from drive wheel sprocket(axle sprocket). Remove bolt and washers from end of engine crankshaft while noting location of spacers and washers for installing new clutch.

Step 3: Remove clutch from engine crankshaft. Install new clutch by aligning key inbore of clutch with keyway in engine crankshaft. Slide clutch onto shaft.
Step 4: Reinstall bolt and washers that hold clutch on crankshaft. Tightenbolt.

Step 5: Reinstall drive chain on clutch and drive wheel sprocket(axlesprocket).

Step 6: Slide engine forward to tighten chain. Chain should have approximately 1/4″ deflection when properly tensioned.

Step 7: Tighten nuts on bottom of engine mounting plate. Reinstall outer drive cover.