Centrifugal Clutch 3/4" Bore #35 Chain 12T for GO Kart Mini Bike Engine 3/4 Bar

Go Kart Centrifugal Clutch 3/4″ Bore 12 Tooth #35 Chain, Up to 7HP engines. Common clutch for 2-7hp engines 2300 300 RPM Perfect for Go Kart Minibike Baja Mini Bike MB165 and MB200, including Baja Heat, Mini Baja and the Baja Warrior Fit 2-6.5hp Honda and Honda Cloned Engines GC160 GC190 GX120 GX140 GX160 GX200 Harbor Freight Greyhound 196cc Harbor Freight Predator 212cc Fit Briggs & Stratton 2 – 6.5 HP with 3/4″ Shaft Fit Centrifical Tecumseh Engines 2 – 6.5 HP with 3/4″ Shaft and Any Other Go Cart Motor Auto Engines with 3/4 Crank Shaft and 3/16″ Key Way 3 4 inch Bar Centrifugal Clutch Performance Parts Designed To be Used on One Wheel Karts with Rear Tires no Larger Than 15″ Tall, Set Screws Included
You Will Get: 1x 12 teeth centrifugal clutch Go Kart Clutch kit includes two set screws, but chain is not included Recommended to always use bolt and washer on end of crankshaft to hold clutch securely onto the shaft
Specifications:

Centrifugal clutch designed to be used on one wheel karts with rear tires no larger than 15″ tall, and engines 2hp-7hp. Larger tires and live axles recommend using Torque-converter ( ASIN:B07T1KRS4V)

Clutch Bore: 3/4″

Sprocket: 12 teeth for #35 chian

Clutch Dia: 107mm

Clutch Height: 55mm

Engagement Speed: 2300 300 RPM

Recommended Engine: 2HP – 6.5HP, 3/4″ shaft with flat key

Fitment: Fit for 2-6.5hp Honda & Honda cloned engines GC160, GC190, GX120, GX140, GX160, GX200 Perfect for Go Kart Minibike Baja Mini Bike MB165 & MB200 (Baja Heat, Mini Baja, Baja Warrior) Common clutch for 3.5-7hp engines using #35 Chain Briggs & Stratton and 2 – 6.5 HP with 3/4″ Shaft Tecumseh Engines 2 – 7 HP with 3/4″ Shaft
How Do You Install A New Clutch on A Go Kart ASSEMBLY INSTRUCTIONS:

Step 1: Remove outer drive cover. Loosen nuts on bottom of engine mounting plate allowing engine to slide back,loosening drive chain.

Step 2: Remove drive chain from drive wheel sprocket(axle sprocket). Remove bolt and washers from end of engine crankshaft while noting location of spacers and washers for installing new clutch.

Step 3: Remove clutch from engine crankshaft. Install new clutch by aligning key inbore of clutch with keyway in engine crankshaft. Slide clutch onto shaft.
Step 4: Reinstall bolt and washers that hold clutch on crankshaft. Tightenbolt.

Step 5: Reinstall drive chain on clutch and drive wheel sprocket(axlesprocket).

Step 6: Slide engine forward to tighten chain. Chain should have approximately 1/4″ deflection when properly tensioned.

Step 7: Tighten nuts on bottom of engine mounting plate. Reinstall outer drive cover.