1. Remove the stock clutch from your ATV or UTV. You will need to remove the primary clutch, belt and secondary clutch. Refer to the service manual for your specific model and make for detailed instructions on how to properly remove the clutch.

2. Install the new driven clutch onto the shaft of the primary clutch. Make sure to align the splines of the driven clutch with the splines of the primary clutch and tighten the retaining nut or bolts to the manufacturer’s specifications.

3. Install the belt onto the primary and driven clutches. Make sure the belt is properly seated on both clutches and that the belt is not twisted.

4. Install the secondary clutch onto the shaft of the driven clutch. Make sure to align the splines of the secondary clutch with the splines of the driven clutch and tighten the retaining nut or bolts to the manufacturer’s specifications.

5. Connect the clutch cable to the secondary clutch and adjust according to the manufacturer’s specifications.

6. Reinstall the primary and secondary clutch covers. Make sure to use the correct bolts and torque them to the manufacturer’s specifications.

7. Start the ATV or UTV and adjust the clutch lever and cable according to the manufacturer’s specifications.

8. Take the ATV or UTV for a test ride and make sure the clutches are adjusted properly. Adjust as needed.

“Keyword”
“how to drive atv with clutch”
“atv clutch holding tool”
“how to drive atv”
“how to drive a quad”