STEP 1: PARK CAR IN A SECURE POSITION

The first step involves hi-jacking the car to raise the front part of the car. Park the car in the right position to make the process easy. Use hi-jack of excellent quality to uplift the car above the ground level. The transmission and engine of the car must be carried out by the hi-jack with stability.

STEP 2: GET THE TRANSAXLE READY TO REMOVE

The next step incorporates the removal of the transaxle to get to the car clutch. For this purpose, unhook the clutch cable and positive battery cables. Disconnect all the electrical connections and speedometer cable. Disconnect and remove the starter motor.

STEP 3: UNBOLT THE ENGINE MOUNT

Locate the bolts that connect the bell housing to the rear engine and remove all of them. Then remove the transaxle away from the engine. Lower the floor jack carefully and remove the car transmission by slightly raising the jack to support the car as well as to remove the transmission from the engine.

Remove the drive axle and prop shaft. To get to the car clutch, you need to remove the pressure plate and slide the clutch disc out. At this step, you can repair or replace the flywheel and remove the dirt and debris from the crankshaft.

STEP 4: REPLACE THE CLUTCH

Before replacing the car clutch, clean all the components to be free of oil, grease, and dirt. After replacing the flywheel, replace the car clutch with a newer one. Slide a new clutch disc and position it using the clutch alignment tool. After sliding the newer clutch disc, bolt on the pressure plate with bolts and replace the transaxle.

STEP 5: REATTACH THE TRANSAXLE

Now you are ready to refit the transmission but before fitting the transmission, assemble the new release bearing with a release lever and fitted with pre-greased pivot points. The tip is to align the transaxle in the spline hole and nuzzle the transaxle forward to reattach it until it glides completely. Don’t rush. Just take your time at this step and practice it a few times until or unless you succeed. Once the transaxle is aligned, now place back the bolts and tighten them properly.

At this step, take support of an additional transmission jack to secure all the pipes, wires, and gear selector linkage to the transmission.

STEP 6: RELEASE THE CAR JACK

After placing the transaxle back at its position and tightening the bolts, release the jack slowly. Hold the transmission and allow the car to lower down back to its original position. Connect the battery and top up the clutch fluid with fresh fluid. Reconnect the electrical plugs, vacuum lines, and speedometer.

Now is the time to hit the road again and test the replaced car clutch. Take a short drive to check that replaced clutch works completely fine.

“Keyword”
“how to remove a stuck centrifugal clutch”
“centrifugal clutch removal tool”
“go kart clutch removal tool”
“how to tell if centrifugal clutch is bad”
“how to adjust a centrifugal clutch”
“club car clutch removal without tool”